The move to the pure sailing ship came with small but steadily increasing technical innovations that more often allowed ships to sail with the wind behind them. Sails changed from a large square canvas suspended from a single yard (top spar), to complex arrangements intended to pivot on the mast depending on the direction and force of the wind. Instead of being driven solely by the wind direction, ships could “sail into the wind” to the extent that the course taken by a ship became the product of a resolution of forces (the actual wind direction and the objective course of the particular ship). Sails were devised to handle gentle breezes and to gain some mileage from them as well as from strong winds and to maintain some choice as to course while under their influence.
Types of sails
Recent News
July 26, 2024, 4:47 AM ET (New York Times)
130 Years After Sinking, Ship is Found on the Bottom of Lake Michigan
While the speed of a rowed ship was mainly determined by the number of oarsmen in the crew, in sailing ships the total spread of canvas in the sails was the main determinant of speed. Because winds are not fixed either as to direction or as to force, gaining the maximum effective propulsion from them requires complexly variable sails. There was one constant that characterized navigation by sail throughout its history—to gain speed it was necessary to increase the number of masts on the ship. Ships in both the Mediterranean and the north were single-masted until about 1400 ce and likely as well to be rigged for one basic type of sail. With experience square sails replaced the simple lateen sails that were the mainstay during the Middle Ages, particularly in the Mediterranean.
In the earlier centuries of sailing ships the dominant rig was the square sail, which features a canvas suspended on a boom, held aloft by the mast, and hung across the longitudinal axis of the ship (as shown in the figure). To utilize the shifting relationship between the desired course of the ship and the present wind direction, the square sail must be twisted on the mast to present an edge to the wind. Among other things this meant that most ships had to have clear decks amidships to permit the shifting of the sail and its boom; most of the deck space was thus monopolized by a single swinging sail. Large sails also required a sizable gang of men to raise and lower the sail (and, when reef ports were introduced, to reef the sail, that is, to reduce its area by gathering up the sail at the reef points).
By 1200 the standard sailing ship in the Mediterranean was two-masted, with the foremast larger and hung with a sail new to ordinary navigation at sea. This was the lateen sail, earlier known to the Egyptians and sailors of the eastern Mediterranean. The lateen sail (as shown in the figure) is triangular in shape and is fixed to a long yard mounted at its middle to the top of the mast. The combination of sails tended to change over the years, though the second mast often carried a square sail.
One broad classification of sails, which included the lateen, was termed “fore-and-aft” sails—that is, those capable of taking the wind on either their front or back surfaces. Such sails are hung along the longitudinal axis of the ship. By tacking to starboard (the right side) the ship would use the wind from one quarter. Tacking to port (the left side) would use a wind coming from the opposite quarter to attain the same objective.
Asian ships
During this same period China, with its vast land areas and poor road communications, was turning to water for transportation. Starting with a dugout canoe, the Chinese joined two canoes with planking, forming a square punt, or raft. Next, the side, the bow, and the stern were built up with planking to form a large, flat-bottomed wooden box. The bow was sharpened with a wedge-shaped addition below the waterline. At the stern, instead of merely hanging a steering oar over one side as did the Western ships, Chinese shipbuilders contrived a watertight box, extending through the deck and bottom, that allowed the steering oar or rudder to be placed on the centreline, thus giving better control. The stern was built to a high, small platform at the stern deck, later called a castle in the West, so that, in a following sea, the ship would remain dry. Thus, in spite of what to Western eyes seemed an ungainly figure, the Chinese junk was an excellent hull for seaworthiness as well as for beaching in shoal (shallow) water. The principal advantage, however, not apparent from an external view, was great structural rigidity. In order to support the side and the bow planking, the Chinese used solid planked walls (bulkheads), running both longitudinally and transversely and dividing the ship into 12 or more compartments, producing not only strength but also protection against damage.
In rigging the Chinese junk was far ahead of Western ships, with sails made of narrow panels, each tied to a sheet (line) at each end so that the force of the wind could be taken in many lines rather than on the mast alone; also, the sail could be hauled about to permit the ship to sail somewhat into the wind. By the 15th century junks had developed into the largest, strongest, and most seaworthy ships in the world. Not until about the 19th century did Western ships catch up in performance.
